香蕉视播

Welcome to Shandong Lugang Machinery Manufacturing Technology Co., Ltd., we will serve you wholeheartedly! /   Website map   /  contact us    Online Message

with quality To survive reputation Seeking development

    30 years' focus on casting products

National service hotline of wood crusher:

0543-4816555

Your location: home page  >  Information Center  >  Company news

Daily maintenance of chip machine

Release time: 2021-04-30

Number of visits: one thousand one hundred and fifty-eight

   no matter what kind of equipment, it is inevitable to encounter some small faults in the process of long-term use. However, if these faults are ignored and continued to be used, the overall efficiency will be affected, and even the machine will stop working. Therefore, the wood chip machine should be maintained in the daily use process. Next, we will learn how to use the chip machine correctly and how to carry out maintenance work to prolong its life.
   after the chip machine stops feeding, the hot air furnace contained in the chip machine will continue to blow hot air into the internal system for about 20 minutes. In this way, the internal components contained in the integrated device can be dried. When the hot air stops, the operator needs to close the valves at the outlet and inlet of the integrated device immediately, In order to avoid outside cold air into the machine. In the process of not using it, you need to clean and maintain the integrated device frequently. After all, it is easy to rust and even get stuck by debris. In the daily inspection process, we need to pay attention to the large diaphragm in the pulse valve of the chip machine. If it is damaged or aged, it must be replaced in time.
    about half an hour before the chip machine stops feeding, the operators must stop the dust shooting and bipolar beating functions, and the ash hopper of the chip machine must maintain the original dust level. As an operator, it is necessary to regularly check the grease in the motor and oil tank of the chip machine. If the grease is too small, it needs to be replenished in time, and the filter of the chip machine should be cleaned every half a month to ensure that the internal air can be kept unobstructed, so as to maintain its normal efficiency in the process of use.
   if the wood chip machine is found to be obstructed in the process of use, it is necessary to stop the machine and find out the reason. It can only be used after the maintenance is completed. When the wood chip machine is not in use, it is necessary to open its inspection door frequently to check whether the filter bag is in normal condition and whether the accumulated dust on its surface is too much, At the same time, find out the causes and eliminate the influence source of the fault. At the same time to add a certain amount of lubricating oil to the bearing, and adhere to every other year to replace it. It is particularly important to keep the surface of the controller clean, so that the efficiency can be guaranteed in the process of use.


 Zp1000 integrated crusher.jpg

Information Center /NEWS

National Service Hotline:

0543-4816555